Home > View All Issues > Volume 36 (March 2023)
Volume 36 : Page 1-126 (March 2023)
Front Cover
|
|
Editorial Pages i-ii
|
|
Table of contents Pages iii-iv
|
|
|
Impact of hot isostatic pressing on surface quality, porosity and performance of Ti6Al4V manufactured by laser powder bed fusion: A brief review Review Article Pages 1-15 Fathin Iliana Jamhari, Farhana Mohd Foudzi, Minhalina Ahmad Buhairi, Norhamidi Muhamad, Intan Fadhlina Mohamed, Abu Bakar Sulong, Nabilah Afiqah Mohd Radzuan
|
|
Microstructural properties and surface roughness of 3D printed open cell-foam Original Research Article Pages 16-31 Fadhilah Shikh Anuar , Khairul Azhar Mustapha, Fatimah Al-Zahrah Mohd Sa'at, Nurul Hilwa Mohd Zini, Ernie Mat Tokit, Satishwara Rao Narasimmanaidu, Kamel Hooman
|
|
Effect of storage tank material on biodiesel stability under different environmental conditions Original Research Article Pages 32-42 Satishwara Rao Narasimmanaidu, Nurul Hilwa Mohd Zini, Mohd Noor Asril Saadun, Fadhilah Shikh Anuar, Mohd Yuhazri Yaakob, Mohd Khairi Mohamed Nor
|
|
Experimental study of contact angle and surface energy of a single aramid fibre and its relation on frictional behaviour of fibre-fibre contact Original Research Article Pages 43-56 Nurhidayah Ismail, Matthijn B. de Rooij, Dik J. Schipper, Nurul Hilwa Mohd Zini
|
|
Morphological and wear behavior of low temperature thermochemical gaseous nitriding process Original Research Article Pages 57-69 Lailatul Harina Paijan, Md. Abd. Maleque
|
|
Experimental investigation of the effect of coating on surface roughness and drill life in drilling of AISI 4140 steel Original Research Article Pages 70-85 Ömer Şahin, Erdinç Kaluç
|
|
Tribological analysis of wire additive manufactured Ti-6Al-4V by electron beam source Original Research Article Pages 86-98 Manjunath A, Anandakrishnan V, Ramachandra S, Parthiban K, Sathish S
|
|
Analysis on tool wear during milling carbon fiber reinforced polymer in dry, coolant and chilled air condition Original Research Article Pages 99-107 Aisyah Madihah Mustafa, Nor Farah Huda Abd Halim, Siti Haryani Tomadi, Najlah Sakinah Shahruddin, Ricca Rahman Nasaruddin
|
|
Classification of animal biomimetic characteristics for tribological applications Original Research Article Pages 108-115 Ai Nurhayati
|
|
Simulation Study of the parameters that affecting the droplets size produced in a Minimum Quantity Lubrication (MQL) system using a Computational Fluid Dynamic (CFD) Original Research Article Pages 116-126 Jaharah A Ghani, Yan Guoliang, Nurul Nadia Nor Hamran, Pin Han Yap, Haniff Abdul Rahman, Wan Mohd Faizal Wan Mahmood, Rizauddin Ramli, Jing Ni, U. Mohammed Iqbal
|
Back Cover |
|
Back Cover |