Editorial

Pages i-ii

PDF (427 KB)

Table of contents

Pages iii-iv

PDF (267 KB)

Fretting wear properties of Nimonic 263 at elevated temperatures _{Original Research Article}

Pages 1-14

Ahmad Afiq Pauzi, Mariyam Jameelah Ghazali, Wan Fathul Hakim W. Zamri

PDF (660 KB) 

Tool wear model and wear mechanisms when machining TiAlN ball end mill with high thermal conductivity steel (HTCS 150) _{Original Research Article}

Pages 15-26

Mohd Fairuz Mohd Rashid, Mohd Hairizal Osman, Mohd Hadzley Abu Bakar, Anis Afuza Azhar, Wan Azahar Wan Yusoff, Kunlapat Thongkaew

PDF (656 KB)

Friction and wear analysis of ceramic cutting tool made from Alumina-Zirconia-Chromia _{Original Research Article}

Pages 27-38

Anis Afuza Azhar, Mohd Hadzley Abu Bakar, Norfauzi Tamin, Umar Al-Amani Azlan, Muhammad Hafiz Hassan

PDF (635 KB)

Bone machining: An analysis of machining parameters such as cutting speed, feed rate, and depth of cut using bovine bone _{Original Research Article}

Pages 39-51

Amos Thounaojam, Anil Kumar Birru

PDF (926 KB)

Influence of rounded cutting-edge radius and machining parameters on surface roughness and tool wear in milling AISI H13 steel under dry and cryogenic machining _{Original Research Article}

Pages 52-64

Husni Nazra Abu Bakar, Jaharah A. Ghani, Che Hassan Che Haron

PDF (530 KB)

The effect of TiAlN-based and AlCrN-based coatings towards mechanical properties on punch tools using finite element method _{Original Research Article}

Pages 65-79

Muhamad Isyraf Bin Aznam, Wan Fathul Hakim W Zamri, Ahmad Kamal Ariffin, Muhammad Faiz Md Din, Intan Fadhlina Mohamed, Guanyu Deng

PDF (668 KB)

The morphological and surface roughness of magnetorheological polished AISI 6010 surface _{Original Research Article}

Pages 80-99

Soffarina M. Soffie, Izwan Ismail, Mutalib A. Nurain, Syarifah N. Aqida

PDF (1115 KB)

Evaluation of tool wear and machining performance by analyzing vibration signal in friction drilling _{Original Research Article}

Pages 100-109

Mohd Zurrayen Abdul Mutalib, Mohd Idris Shah Ismail, Azizan As'arry, Nawal Aswan Abdul Jalil

PDF (627 KB)

An experimental investigation on tribological performance of UHMWPE composite under textured dry sliding conditions _{Original Research Article}

Pages 110-125

Vishnu Sadashiv Aher, Uddhav M. Shirsat, Vishnu D. Wakchaure, Venkatesh M.A.

PDF (1078 KB)

Surface characterization of heat-affected zone in robot-based increment sheet forming _{Original Research Article}

Pages 126-134

Nazarul Abidin Ismail, Mohd Idris Shah Ismail, Mohd Khairol Anuar Mohd Ariffin, Azizan As’arry

PDF (696 KB)